Setting Up Ham Radio Deluxe CW Mode with Winkey II and FT-857D

As an amateur radio operator, using ham radio deluxe (HRD) to transmit and receive morse code is a great way to improve your skills. However, setting up the system can be overwhelming for beginners. In this article, we will guide you through the process of setting up HRD CW mode with Winkey II and FT-857D.

Firstly, connect your Winkey II to your computer via USB. The Com4 port is used in our example, but this may vary depending on your machine's configuration. Next, open HRD and navigate to the 'CW' tab in the dialog box. Select 'Modes IDs' from the left menu to access the settings.

The next step is to set up your radio to CW mode. In our case, we used the FT-857D, but most radios should work with similar settings. Make sure your radio is set to CW mode and experiment with different 'Break-In' settings (Full or Semi) until you find a configuration that works for you.

The following setup is typical of the Winkey II screens used in HRD. The process may vary depending on your specific equipment, but this should give you a good starting point.

It's worth noting that while our example uses the FT-857D, most settings should work with most radios. If you encounter any issues during setup, refer to the HRD knowledgebase or consult with fellow amateur radio operators for assistance.

In conclusion, setting up ham radio deluxe CW mode with Winkey II and FT-857D is a relatively straightforward process. By following these steps and experimenting with different settings, you should be able to get started with morse code transmission and reception in no time.

Ham radio deluxe cw